STEP 1: Stir contents well before and during use. Apply two coats with a roller or brush. (You can use our Liquid Carbon underneath as an undercoat if you are wanting 100% full black coverage).
allowing 4–6 hours drying time between coats. When second coat is just touch-dry, proceed to Step 2.
STEP 2: Stir contents well before and during use. Apply one coat of Rusted Activator . After thirty minutes spray water over surface, but do not over-spray. Keep the surface moist for a minimum of two hours. You may continue to spray water until satisfied with the effect, for up to four days. Once the desired finish is achieved and is completely dry, apply one coat of STEP 3 (flat sealer) to prevent further oxidation effects.
Approximate coverage rate:
Rusted cast iron paint(step 1) – 3-4 square metres per litre
Rusted Activator(step 2) – 9-10 metres per litre
Rusted Sealer(step 3) -: 6–10 square metres per litre, depending on application technique and surface roughness.
Safety and Environmental Care
Personal Protection: Wear eye protection and dust mask when spraying, as splashes may cause eye irritation and inhalation of spray mist may cause respiratory irritation.
Keep out of reach of children
Refer to State/Territory Land Waste Management Authority: most authorities permit disposal at approved land waste sites.